QO100 next steps...

Got myself a Heil headset for the laptop as the built-in mic picked up room noise. So, I figured it was time to try a QSO on QO100 even with the floating (frequency wise) Pluto. And - success! I had a short QSO with a German station. Just waiting for some small signal diodes to arrive before I glue the GPSDO output to the Pluto. There is a modification that involves removing the 40MHz TCXO and connecting an external source but the Leo Bodnar GPSDO output is 3.3V, too much for the chip in the Pluto. The mod involves two diodes in antiparallel to earth, plus a capacitor between the Pluto chip and the diodes, and another between the diodes and GPSDO. Hopefully that will work and the surgery on the Pluto does not consign it to the scrap pile! The GPSDO I have has two outputs, one 25MHz to the LNB, and one 40MHz for the Pluto. I still need to sort the dish as signal strengths are still below where I expected. I am also concerned at the filter/pre-amp because it does not draw as much current as it is supposed to - it works but I wonder…

Overcast today so I made time to try to align the dish a little better. One long Ethernet cable got the laptop under the dish and with SDR Console looking at the beacon I did manage to peak it a bit but I think I can do better yet. Oddly, no amount of moving the POTY in or out or skewing it made any noticeable difference. I did note however that the rain cover I made only makes a tiny bit of difference. The sky is a little overcast today so maybe signals are down because of the cloud cover. Anyway, I made a test CQ call and could hear my voice coming via the WebSDR nicely, so I made a couple of CQ calls but got no reply. I think I chased everyone away because after this there was very little activity. So, at least I know I am getting out and so a success at least in part. One thing though, the tuning is going to take some getting used to yet. The basic frequency conversion between the 10GHz band, the 2.4GHz transmit and 739MHz receive is 10GHz - 9750 = 739MHz rx frequency, and 10GHz - 8089.5…

After ages I finally made a rain cover for the POTY and led cables into the garage. Big delay there because the garage was a tip. It still is a tip, but the mess has been rearranged so I have access to the air brick where the cables come in! It's nice that when they built the house in the 1930's they put an air brick right there knowing it would be needed for a satellite dish... The rain cover is made from a sheet of plastic that came out of a smashed LCD monitor. I bent it round a bit of 110mm drain pipe using a hot air gun. it didn't quite come out as intended but it's near enough. The front is from the same piece of plastic and is epoxy glued on - yes there is a gap where the glue was less gluey, I'll fix that later. Nylon threaded bar and nuts hold it in place. And it rained an hour after I made it so it does actually work. After all the messing about everything still works. There is a nice box on order to take the gubbins - ok, the Pluto, bias tee, Leo…