QO100 sort-of success

After some fiddling I now have a decent amount of signal coming down from QO100, but also questions. The azimuth was already correct and I had adjusted that to maximum signal strength on a TV channel with a GT Media V8 Finder. But the elevation is numerically wrong, or the markings on the dish are wrong, which is more likely. Fiddling with elevation got the strongest beacon signal at about 26db and 26 degrees marked, but the AMSAT info says it should be around 23 degrees at my QTH. Mind you, for all I know the garage wall is not perfectly vertical! All SSB signals look good now except for one or two that are difficult to hear. However, having got that far, no adjustment to the position of the POTY in the arm or its skew make any noticeable difference, so I've left that one. Also, when transmitting a tone from SDR Console it actually peaks higher than the beacon so I had to reduce the drive appropriately. An SSB signal test showed very poor audio and no adjustments in SDR Console got it to where it needed to be. Turning the mic gain up in Windows itself cured…

Got myself a Heil headset for the laptop as the built-in mic picked up room noise. So, I figured it was time to try a QSO on QO100 even with the floating (frequency wise) Pluto. And - success! I had a short QSO with a German station. Just waiting for some small signal diodes to arrive before I glue the GPSDO output to the Pluto. There is a modification that involves removing the 40MHz TCXO and connecting an external source but the Leo Bodnar GPSDO output is 3.3V, too much for the chip in the Pluto. The mod involves two diodes in antiparallel to earth, plus a capacitor between the Pluto chip and the diodes, and another between the diodes and GPSDO. Hopefully that will work and the surgery on the Pluto does not consign it to the scrap pile! The GPSDO I have has two outputs, one 25MHz to the LNB, and one 40MHz for the Pluto. I still need to sort the dish as signal strengths are still below where I expected. I am also concerned at the filter/pre-amp because it does not draw as much current as it is supposed to - it works but I wonder…

After ages I finally made a rain cover for the POTY and led cables into the garage. Big delay there because the garage was a tip. It still is a tip, but the mess has been rearranged so I have access to the air brick where the cables come in! It's nice that when they built the house in the 1930's they put an air brick right there knowing it would be needed for a satellite dish... The rain cover is made from a sheet of plastic that came out of a smashed LCD monitor. I bent it round a bit of 110mm drain pipe using a hot air gun. it didn't quite come out as intended but it's near enough. The front is from the same piece of plastic and is epoxy glued on - yes there is a gap where the glue was less gluey, I'll fix that later. Nylon threaded bar and nuts hold it in place. And it rained an hour after I made it so it does actually work. After all the messing about everything still works. There is a nice box on order to take the gubbins - ok, the Pluto, bias tee, Leo…