Electronics ⁽²⁴⁾

Slowly coming together. Yesterday I decided to attack the front panel with a drill and mount the rotary encoder, switches and the little Arduino board which I programmed earlier. This is for tuning the Langstone. For some reason my drill press insists on making triangular holes - if I wanted a triangular hole I'd never manage of course. So I've resorted to making a smaller hole and using a round file. Anyway, everything went into place, although the Arduino board has no mounting holes so I've tie-wrapped a piece of plastic under it as an insulator and used a decent (hopefully!) sticky pad to secure the board inside the front panel. So far, so good. Here it is receiving the Allstar microHub... I need to sort the microphone out. The USB audio dongles seem to be constructed for stereo input so I wired the same to the front panel. Plugging the headset in gives no audio, presumably its all shorting out. I can make it work by 'adjusting' the plug (pulling it out until it works!) so I need to re-wire or make a little adapter. There are a couple of fans in the case and so far it seems…

I’ve been looking for some time for an affordable (i.e. used) and useful ranged (i.e. not cheap!) spectrum analyser. Obviously I want DC to light but don’t need it and don’t want to sell the house for a bit of test gear. I have a TinySA which is good to 960MHz but I will need a higher frequency range as I fiddle more with microwaves. The ultimate, e.g. a Rigol or Siglent LCD type device is just far too expensive. Nice to have yes but something one would need to be using all the time in order to justify it. Then I came across Satsagen - http://www.albfer.com/en/2020/02/21/satsagen-2/ Satsagen runs under Windows and by default uses an Adalm Pluto as its interface to the real world. The software even does the necessary to upgrade the Pluto to the ‘full’ range of 70MHz to 6GHz (you can do this easily by hand but it’s nice of the software to do it anyway). The software has three basic function too - spectrum analyser, spectrum analyser with tracking, and generator. So, one PC, one Pluto, Satsagen and you get a pretty decent 70MHz to 6GHz spectrum analyser, tracking generator and signal generator. I have…

The PiBox is almost completed. It's taken far too long due to all sorts of silly things like having to get fans because a dry run indicated the poor little boards were getting a bit hot, having to get bolts for the fans because I had none long enough, and having to get a connector for the 1-wire (actually 3 wires!) lead from the central heating sensors. So, there is is. Two fans on the left, 5V PSU bottom right, gigabit Ethernet switch above that, then the Pi's: top is the PiStar with the DVMega board which has coax to the rear panel and then a dummy load, middle is the ASD-B and central heating monitor Pi, and the bottom is a general purpose one with various bits on such as rtl_tcp. The lower two boards have USB-A sockets on the rear of the case for the two SDR sticks, one for the ADS-B antenna and one to attach to a Discone for general use. But there is an issue. I had originally intended this to sit in the shack but those fans are just too annoying. Not loud, but constant. I suspect the box will end up in the…

Well of course you need a soldering station that matches your desk tidy...